Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What's the problem inside the Air Compressor ?

Status
Not open for further replies.

munzir

Full Member level 6
Joined
Oct 11, 2011
Messages
365
Helped
22
Reputation
44
Reaction score
21
Trophy points
1,298
Location
Pak
Activity points
3,795
What's the problem inside the Air Compressor ?

Model : GA11FF Workplace Air System (Atlas Copco)

Loading pressure : 7 bar to 8 bar

Loading Amps (Max) : 25 Amps

Unloading pressure : 8 bar to 7 bar

Unloading Amps (Max) : 12.5 Amps

Loading and unloading process takes less than 30 seconds.

The problem is that sometimes while unloading the electronic display shows the message "program stopped " nearly around 7.7 bar and keeps on unloading till 7.4 bar and then displays the message that " motor stopped" and really the motor stops for a while and as the pressure drops to 7 bar the motor and the system starts working fine and starts loading .

Motor Rated FLA is 35 Amps , 3 phase 380 to 400 V ac , supply

What might be the problem ?
thanks
 

Dear Munzir,

Your air compressor controller is running normal.
When there is no compressed air demand on your network, the controller will count down the setting of "min stop time" and trigger to programmed stop the electromotor for saving energy consumption.
As it reach the loading pressure, the controller will start the electromotor again.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top