Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What is the purpose of post processing in Ansoft designer?

Status
Not open for further replies.

hjzs18

Junior Member level 3
Joined
Dec 8, 2005
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,506
HI, there,
just a newbie question for ansoft designer ,here, i am learning this SW by examples, In one of them, the procedure is, after setting the port, i am asked to set port excitation post process. In the dialogbox, I am asked to check the ports and check "Gap source". What is the purpose of doing this? what does the gag source mean?any ideas ??

TIA
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top