Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What is main rule of ENC28j60 INT pin?

Status
Not open for further replies.
S

Sharagim

Advanced Member level 4
Full Member level 1
Joined
Feb 6, 2011
Messages
112
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Visit site
Activity points
2,058
Hi,
What is INT pin rule in ENC28j60 because I see it is working when is NC.

BR,
 

its basically there to provide an interrupt signal to your host controller saying there is some transaction at ethernet.
 

I am looking for some solution to test and see if the module working properly. I was thinking on connecting clkout to a timer and check the freq. but I think it wont help very much.
Now you think is it possible to use INT?
I dont know why sometimes my enc28j60 hang and wont response ? at the same time I see my micro working properly.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top