very good effort,
I felt the lack of an oscilloscope and signal generator in MPLabIDE,
these facilities are available in PICSimulatorIDE.
Hope you will include it in your project.
Best of luck for your effort.
Yes namqn,
In the Stimulus controller I can fire inputs to the micro, I have checked the Simulator Trace also. I didn't found any scope there, In PicSimulator IDE, there is a 4 channel online scope (user friendly)!!! and I can fire any input just clicking appropriate bit coloumn.no need to configure first like MPLABIDE!!!!
I have the following
1- ability to display user defined variables in user selected format (hex,decimal, octal ..). Now it is just hex format.
2- robust and free C complier
3- ability to simulate differnt serial protocols (currently only UART is supported)
4- ability to apply analog volt level on A/D input channels. for simplicitly, it could be edited each time.
They are all what I have for now
May be I will add more later
Set the Cursor (the PIC) to the line in the source code where I double click (like Visual Studio -> for Visual Bsasic).
No I have to rigth click in the line and chosse "Set PC at cursor".
Ok, all noted but most of these suggestions relays on the simulator module. The sim module I try to use actually is GPSIM. I'm planning to create a new project fully written in JAVA that will interface natively with my Eclipse IDE.
The first Alpha version of mcuStudio will be posted in few days. Stay tunned. http://www.pocketmt.com
Best regards