Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Waveguide Termination simulation and analyze (in HFSS)

Status
Not open for further replies.
Z

zhul3

Member level 5
Joined
Feb 11, 2008
Messages
90
Helped
7
Reputation
14
Reaction score
3
Trophy points
1,288
Location
canada
Activity points
1,855
Hello,

I am planning to simulate a waveguide termination to analyze the power dissipation of the load material, but not quite sure how to create the load materials with correct parameter.

I know there is an important parameter, Attenuation Ratio, for the load material. But how should hfss model reflect this parameter? Right now in the Model, I just make a huge “dielectric loss tangent” 0.45 to get a good RL, but I believe this wouldn’t be true in reality.....

Can anybody give some suggestion?

Thanks in advance.

Lee
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top