Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

voice recognition using RS232, MAX232, RF Tx Rx

Status
Not open for further replies.

suelooi

Newbie level 4
Joined
Aug 23, 2009
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Australia
Activity points
1,408
rf tx rx

Hi,

I am doing a project of automating the mobile robot to a voice recognition robot. I plan to use the computer as the input and so serial port to send out data and covert it using MAX232 to the RF Tx and then the RF Rx will send out signal to the PIC of the mobile robot to drive the motor. May I know how can I connect the MAX232 to RS232? I need at least 4 input commands for the movements of the mobile robot. I am open too if there's any other ideas of automating the robot to voice recognition. Thanks.

Sue
 

rs232 voice recognition

check this book about serial port it is good
 

burningsmell.org/biollante/max232.gif

suelooi said:
Hi,
May I know how can I connect the MAX232 to RS232?
Just read the MAX232 datasheet. There are several useful circtuits there. I hope most of your questions will be solved. Good luck!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top