j hemangini
Member level 1
vhdl serial communication
According to written in datasheet Using a standard, straight-through 9-pin serial cable, then on pressing number key 0,1,2 & 3 hypertermina should show following diaplay .
-----------------------------------------------------------------------------------------------
The key features of the Spartan-3A Starter Kit board are:
• Xilinx 700K-gate XC3S700A Spartan-3A FPGA in the Pb-free 484-ball BGA package
(FGG484)
• 4 Mbit Xilinx Platform Flash configuration PROM
• 64 MByte (512 Mbit) of DDR2 SDRAM, 32Mx16 data interface
• 4 MByte (32 Mbit) of parallel NOR Flash
♦ FPGA configuration storage
♦ MicroBlaze code storage/shadowing
♦ x8 or x16 data interface after configuration
• Two 16 Mbit SPI serial Flash
♦ STMicroelectronics and Atmel DataFlash serial architectures
♦ FPGA configuration storage
- Supports single configuration bitstream or multiple MultiBoot configuration
bitstreams
♦ Nonvolatile data storage
Figure 1-6: Use HyperTerminal and a Standard Serial Cable to Connect to Board
UG330_c1_06_032207
----------------------------------------------------------------------------------------------
But i am not getting any display on hyperterminal. What should be the problem.
if anyone have answer then please tell me.
According to written in datasheet Using a standard, straight-through 9-pin serial cable, then on pressing number key 0,1,2 & 3 hypertermina should show following diaplay .
-----------------------------------------------------------------------------------------------
The key features of the Spartan-3A Starter Kit board are:
• Xilinx 700K-gate XC3S700A Spartan-3A FPGA in the Pb-free 484-ball BGA package
(FGG484)
• 4 Mbit Xilinx Platform Flash configuration PROM
• 64 MByte (512 Mbit) of DDR2 SDRAM, 32Mx16 data interface
• 4 MByte (32 Mbit) of parallel NOR Flash
♦ FPGA configuration storage
♦ MicroBlaze code storage/shadowing
♦ x8 or x16 data interface after configuration
• Two 16 Mbit SPI serial Flash
♦ STMicroelectronics and Atmel DataFlash serial architectures
♦ FPGA configuration storage
- Supports single configuration bitstream or multiple MultiBoot configuration
bitstreams
♦ Nonvolatile data storage
Figure 1-6: Use HyperTerminal and a Standard Serial Cable to Connect to Board
UG330_c1_06_032207
----------------------------------------------------------------------------------------------
But i am not getting any display on hyperterminal. What should be the problem.
if anyone have answer then please tell me.