Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am using Vertix XCV50 (XESS BOARD V1.1) ,on configuring the device i get an error of "CABLE CONNECTION FAILED",What should i do in order to configure the device?
hi
make sure that you are using the right cable. if u are using IMPACT then right
click and select 'cable auto detect'. this should automatically detect your cable.
u can refer to the IMPACT help documentation for details and troubleshooting
You must ensure that You have only one impact window and no one programm not open port for it's use. Next try to use last version of software...
Good Lack
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
