Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What is Ls & Lg method?
What is the frequency range for matching?
What is O/p impedance?
Suppose you want to match 258-j670 ohm to 50 ohm & want to use L-C PI network
also let us assume you are Matching for frequency range 100 to 500 MHz
then matching will be as shown in attachment
only use source degenerater and gate inductor to match 50
center frequency is 2.4 GHz
and in your example the inductor value is huge
no process supply this value
I just shown you what type of network matching can be used.
You did not specified frequency, so i did not used to show microstrip elements for matching.
If you have Agileng Genesys you can do matching using any type of network you want.
Best of luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.