Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

USB to UART converter (FT234)

Status
Not open for further replies.

janarthananjd

Newbie level 2
Joined
Oct 23, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
17
Dear All
I have Designed USB to TTL which i selected FT234 IC. in that there is the pin called CTS and RTS. without connecting that two pin how i complete my design.
 

barry

Advanced Member level 5
Joined
Mar 31, 2005
Messages
5,948
Helped
1,172
Reputation
2,356
Reaction score
1,300
Trophy points
1,393
Location
California, USA
Activity points
32,348
It depends on what you want your design to do. WE sure don't know.

RTS and CTS are handshaking signals. Maybe you need them. Maybe you don't. Are you intending to use hardware handshaking? If so, you'll need them. Are you going to use XON/XOFF handshaking? If so, then you won't need them.
 

janarthananjd

Newbie level 2
Joined
Oct 23, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
17
we are planing to use only Rx and Tx pins without handshaking signal. if yes, how would the connection with MCU(RL78f13).
 

barry

Advanced Member level 5
Joined
Mar 31, 2005
Messages
5,948
Helped
1,172
Reputation
2,356
Reaction score
1,300
Trophy points
1,393
Location
California, USA
Activity points
32,348
RX of device to TX of MCU and TX of device to RX of MCU. I'm not really sure I understand your question.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top