[SOLVED] USB IR remote using PIC2550

Status
Not open for further replies.
First you simply try to decode the IR signal in PIC2550 then move on to USB.
 

The firmware is given on the site - so it shouldn't be that difficult to make it work?
Have you tried their firmware, and followed the guide to set up the reciever driver (.INF) and such?

Thomas
 

mindthomas said:
The firmware is given on the site - so it shouldn't be that difficult to make it work?
Have you tried their firmware, and followed the guide to set up the reciever driver (.INF) and such?

Thomas
Click to expand...

I tried with the firmware, USB device was detected and the (.inf) drivers was installed successfully. But when i press remote, there is no output in Hercules software or in Grider software
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…