Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

USB AVR programmer to program ATmega and AT-89-S-51 series microcontrollers

Status
Not open for further replies.

MonsterSocket

Newbie level 4
Joined
May 5, 2015
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
33
Reference Previous Thread:

https://www.edaboard.com/threads/200935/

I'm trying to get a AT89s51 to program, I am new to this as far as programming chips...

If i construct this board for programming a AT89s51

Can i program the chip on the programmer board after being built, or do i need to program it separately

- - - Updated - - -

Can i just Use a USBASP to program the AT89s51 or do i need to build my own and have the mentioned Hex file burned into the programmer board/chip?

Seriously is there an easier way today to program these 89s chips since this thread is now a few years old?
 

Ran across this site where someone has written a program for the USBasp programmer to program an AT89S51. I don't know if this is a viable solution to the problem. It looks like one has to create an account to download the software to convert the USBasp to program the AT89S51. I have used an Arduino Mega as a programmer to program eeproms (28C256) on a breadboard. That would be a way to parallel program the chip, which takes a lot of bus lines.

https://www.8051projects.info/resources/usb-8051-avr-programmer.23/
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top