shoeb.eee
Member level 1
I wanted to program a ATmega8 with a test program but failed. I used ponyprog for this purpose.
When I waned to read the program (read all from command menu) it can read without any error.
When I load hex file and issue Write all command, it show progress bar but at last it showed Write failed.
What can I do now. I want your suggestion.
[Calibration is also ok]
When I waned to read the program (read all from command menu) it can read without any error.
When I load hex file and issue Write all command, it show progress bar but at last it showed Write failed.
What can I do now. I want your suggestion.
[Calibration is also ok]