elisemark
Junior Member level 1
- Joined
- Oct 7, 2010
- Messages
- 17
- Helped
- 2
- Reputation
- 4
- Reaction score
- 1
- Trophy points
- 1,283
- Location
- Buffalo, NY
- Activity points
- 1,390
Hi all,
I have a simple circuit , where I take a signal and remove the DC offset with a trim pot prior to Amplifying signal through an active RC filter (TL081) . Now I can adjust the pot and get the signal close to 0 removing the offset but then after few sec the signal goes higher and higher until it reaches almost VCC and flattens out probably satturating the amplifier . Anyone has an idea why this is happening ?
I have a simple circuit , where I take a signal and remove the DC offset with a trim pot prior to Amplifying signal through an active RC filter (TL081) . Now I can adjust the pot and get the signal close to 0 removing the offset but then after few sec the signal goes higher and higher until it reaches almost VCC and flattens out probably satturating the amplifier . Anyone has an idea why this is happening ?