Sorry for being unclear, "Don't mind specific component values." I ment that this schematic is not accurate in regard to values, the resistor divider values are bunk, they should be 160k, 20k and 10k or there about.
And the input voltage is or was restricted to exactly 36V but I have now changed regulator to TPS7A4001. Its a high voltage(10-100Vdc input, 1,2V-90V output) regulator that comes in a much easier IC package, MSOP8 instead of VQFN20.
There are a 48V version as well but I might try to build some high voltage supply later, and no the datasheet does not show any such circuit.
But I hope that I can realize some kind of circuit such as this, as it is know I kind of have to since TPS7A4001 can only handle 50mA instead of 1A as 4701 does.
But it all comes down to if the ripple is being attenuated, as if the regulator output where being given a higher current capability while maintaining the voltage quality.
I have had trouble using a VQFN package properly but know that I have TPS7A4001 in MSOP8 I will finish the board and print out the overhead and etch a prototype, I hope there will be no oscillations due to the circuit but we shall see.