Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: tool for orcad capture_10.5(schematic) transfer in pads
Orcad Capture is much better schematics tool than PADS. However, PADS has better layout tool than Orcad Layout. You are better off leaving schematics in Orcad Capture.
Re: tool for orcad capture_10.5(schematic) transfer in pads
Thanks drwho for answer, but I think we missunderstood.
I need tool for transfer schematic project into PADS2005 to make board layout.
I have had before - when I was using ORCAD9.2 it was posible to transfer it(schematic) into PADS through the PCB navigator.But now PCB nav5.0 does not support ORCAD10.5.:|
This is my big problem because I have to make ratsnest manual!?
Tnx for your answer again.
Re: tool for orcad capture_10.5(schematic) transfer in pads
Netlist out to Pads - you may want to look at **broken link removed** for an add on netlister, the built-in pads option doesn't always work out - change the file extension to .asc from .net and acii import into pads - of course all of your decals must be placed. Changes - ECO in the same way.
Re: tool for orcad capture_10.5(schematic) transfer in pads
hello Mr. 9a4wy
there is a link from which u can download orcad to pads translators
u can use them for pads 2005.
i think now u can use capture for schematic and layout in pads
there are also useful scripts on this link
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.