Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

TMAX Pre-clock & end-of-cycle Measurement problem

Status
Not open for further replies.

luwanzen

Newbie level 2
Joined
Apr 14, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
Dear all,
I have some problems about the pre-clock and end-of-cycle measurement,
1. what's the pros. and cons. between the pre-clock measurement and end-of-cycle measurement ?
2. In the pre-clcok measurement, why does we need the vector named ""Internal_scan_pre_shift" in the load_unload procedure? why does the tool merge this vector into the shift vector?

Thanks a lot!
 

Hi luwanzen,

Did you get the answer for the question you posted?? I am still looking for it.

Regards.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top