Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
#frist: some tool can accept constrain from U and check if U violate this constran or not.Other have not then U will write out the constrain and then rout the bouard then check u'r board manually.
#second:in general tack this guide 4 U
1- decide which signal is critical , the critical signal depend on it's rise time. from rise time U can get Critical length. from U'r PCB program check if U pass this length or not.
2- if there are some signal not pass find the way to match it at the reciver, to demamd the ringing due to reflection.
3- check the distance between track pass 3W rule or not to eleminate Cross talk.