Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

symbol error rate verses average received power in awgn at OFDM

Status
Not open for further replies.

zunayeed

Junior Member level 1
Joined
May 4, 2011
Messages
15
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,373
recpvser.jpg

can any body tell me if the graph i plotted is correct or not? if not then how to correct it? please explain..
need ur comments and feedback.

thanks in advance
 

Could you plz give us more details, how does the SER increase with the increase of received power?
 

for example i have 10 data blocks
and took 5 symbols in in data block
and then i measured avg power for each data block in awgn. then at receiver side i plotted avg received power vs ber
 

I've never seen this before zunayeed, but if you want to check your code, plot the conventional BER vs. SNR and it would roughly be 10^-5 at 10 dB SNR. Good luck :)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top