Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Switching power to Motor Driver and Encoder

Status
Not open for further replies.

nahidalam

Junior Member level 3
Joined
Apr 27, 2011
Messages
27
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,522
The control system I am designing has an H-bridge motor driver and and Encoder. We want to control the power to those devices so we can selectively power it on or off for the purpose of saving power.

We are planning to use this MOS module (https://www.uctronics.com/dc-5-40v-irf3205-50a-mos-module-for-hot-bed-3d-printer.html) as a switch. Problem is, there is not enough documentation on how to use it - connection etc. Any suggestion?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top