Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

sweep parameters in cadence/hspice

Status
Not open for further replies.
S

shanmei

Advanced Member level 1
Joined
Jul 26, 2006
Messages
430
Helped
8
Reputation
16
Reaction score
8
Trophy points
1,298
Location
USA
Activity points
4,496
It is easy to sweep parameters in cadence/hspice, but how to sweep the number of devices?

For example, I want to know the simulation results with one inverter, two inverter, three inverter.... How can I set the number of inverter and sweep? Thanks.
 

it is easy
you can simulate all of your inverters at same time with different output names and show them in cscope.
So easy
best wishes
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top