Jul 22, 2016 #1 S snipex Junior Member level 3 Joined May 23, 2016 Messages 29 Helped 2 Reputation 4 Reaction score 2 Trophy points 3 Activity points 284 Hi, I'm currently working on a FRDM-KEAZ128 board. The plan is to then use this mcu on a custom PCB and program it. I looked for some programmers and there seems to be only two (Cyclone MAX and Flasher ARM). Both are extremely expensive. Then I found this debugger but I don't know if I can program with it: https://si.farnell.com/nxp/u-multilink/dev-interface-mcu-development/dp/2315740 I also found another way but this is not ideal: https://mcuoneclipse.com/2013/04/21/using-the-freedom-board-as-jtag-programmer/ Does anybody has any experience with this? It would be great if the programmer would be below 200€.
Hi, I'm currently working on a FRDM-KEAZ128 board. The plan is to then use this mcu on a custom PCB and program it. I looked for some programmers and there seems to be only two (Cyclone MAX and Flasher ARM). Both are extremely expensive. Then I found this debugger but I don't know if I can program with it: https://si.farnell.com/nxp/u-multilink/dev-interface-mcu-development/dp/2315740 I also found another way but this is not ideal: https://mcuoneclipse.com/2013/04/21/using-the-freedom-board-as-jtag-programmer/ Does anybody has any experience with this? It would be great if the programmer would be below 200€.