Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Suggest me the RF block and ground placement in CC1101 RF transceiver

Status
Not open for further replies.

darko79

Newbie level 6
Joined
Mar 15, 2005
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,417
Dear,
I am new in RF. Here is my board with Ethernet PIC and CC1101 RF transceiver. I want suggetion is it ok placment of RF block, ground placement and all other suggetion. Width of line from RF section to chip antenna is 3mm. I calculate that for FR4 1.6mm with Er=4.2 I work on 433MHz, 3mm is width for 50R impedance. Please suggest.
Best regards,
Darko
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top