Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

sub-parameter in in Ibis model in PSD15.1

Status
Not open for further replies.

Serg_SV

Member level 3
Joined
Jun 30, 2004
Messages
66
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
429
What does mean sub-parameter's ground_clamp_bus and power_clamp_bus for IbisPinMap?

For sub-parameter's ground_bus and power_bus I have to write number of pin'c that connected to GND and VCC accordingly.
for example for 74ALS04N
(IbisPinMap
(1
(C 1.17e-12 )
(L 6.1e-09 )
(R 0 )
(WireNumber 1 )
(signal A0 )
(signal_model ALS04N_IN_PNP )
(power_bus pwrbus14 )
(ground_bus gndbus7 ) )

If I have component, that has several pin's for connect to GND and VCC. How must I write sub-parameter's ground_bus and power_bus it my model?
Thank you.
Serg.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top