fireball003
Full Member level 3
icd2 clone circuit
Hi,
I built an ICD2 based on Stolz , but somehow that is not working. Please tell me how will I check if my circuit setup is correct. I did the following-
1. I burnt bootloader BL010101.hex (2.98 KB) using another ICD2 in PIC16F877
2. When i try to connect ICD2 to MPLAB using serial port then in pin 37 of pic16f877 the voltage goes from 5v to 4.1 v...again if I disconnect the serial cable then it becomes 5v.
3. when I try to connect then it shows the error-
ICDWarn0034: Please ensure that your system's serial FIFO buffers are disabled.
Connecting to MPLAB ICD 2
ICD0021: Unable to connect with MPLAB ICD 2
MPLAB ICD 2 Ready
4. I didn't connect to any terget device.
What test should I run to check if the hardware or bootloader has any problem?
Thanks a lot.
Added after 1 hours 34 minutes:
While I was checking the voltage in serial port, I got the following-
pin 2 --> (2.3v)
pin 3 --> (- 9.7v)
pin 4 --> (5.1v)
pin 7 --> (9.7v)
pin 8 --> (-2.7v)
What test should I do to solve this problem??
Please help me out of this problem.
Hi,
I built an ICD2 based on Stolz , but somehow that is not working. Please tell me how will I check if my circuit setup is correct. I did the following-
1. I burnt bootloader BL010101.hex (2.98 KB) using another ICD2 in PIC16F877
2. When i try to connect ICD2 to MPLAB using serial port then in pin 37 of pic16f877 the voltage goes from 5v to 4.1 v...again if I disconnect the serial cable then it becomes 5v.
3. when I try to connect then it shows the error-
ICDWarn0034: Please ensure that your system's serial FIFO buffers are disabled.
Connecting to MPLAB ICD 2
ICD0021: Unable to connect with MPLAB ICD 2
MPLAB ICD 2 Ready
4. I didn't connect to any terget device.
What test should I run to check if the hardware or bootloader has any problem?
Thanks a lot.
Added after 1 hours 34 minutes:
While I was checking the voltage in serial port, I got the following-
pin 2 --> (2.3v)
pin 3 --> (- 9.7v)
pin 4 --> (5.1v)
pin 7 --> (9.7v)
pin 8 --> (-2.7v)
What test should I do to solve this problem??
Please help me out of this problem.