Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Standard PCB form factor and mounting size

Status
Not open for further replies.

the_owl

Junior Member level 1
Joined
Sep 29, 2010
Messages
15
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,376
Hi all,

Can anyone tell me what are the standard Form Factor for PCB?
And also the mounting hole size and the location of it.

Is mounting hole = tooling hole? Used for screw a stand for PCB? Where should it be located normally (how far from the board edge?)

Thank you.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top