Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Square wave inverter cct not working plz help

Status
Not open for further replies.
M

mugheesnawaz

Member level 1
Joined
May 1, 2013
Messages
39
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,605
i want to make a 100w square wave inverter to drive a resistive load.power rating of inverter isn't an absolute criteria.firstly it isnt working.i have followed a circuit from internet but it isnt working.kindly help me figure out.

i have attached cct diagram and proteus design file

inverter.pngView attachment inverter.rar
 

Hi,
Can you define not working? I would not drive two power FETs directly from a C-MOS 4000 device. I would require a gate drive IC in the way to drive them properly.

Rob.
 

Your circuit is almost the same as mine. Mine works fine and since the frequency is so low then a gate driver IC is not needed.

Not many products today work properly when fed a squarewave.
 

Attachments

  • inverter.png
    inverter.png
    128.9 KB · Views: 110

this is a basic circuit, why it should not work?
replace the IC and Mosfets and see
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top