Beffo
Junior Member level 2
I want to split a net in two in Orcad Layout.... How to do?
The reason is: There is a MOSFET Bridge with high currents. There shall also be sensing components connected to the bridge.
My problem is that the small signal sensing components also gets routed with "fat" connections. So I want the components to belong to different NETS...
The reason is: There is a MOSFET Bridge with high currents. There shall also be sensing components connected to the bridge.
My problem is that the small signal sensing components also gets routed with "fat" connections. So I want the components to belong to different NETS...