yefj
Advanced Member level 4
Hello , I Need to communicate my EFM32LG with a dac80004 USING SPI.
When i define USART in SPI mode i need to define the pins and ports as follwoing:
Port A pin 2: chip select sync_not (active low)
Port E pin 10: MOSI (SDIN)
Port E pin 11: MISO (serial interface digital out)
Port E pin 12: SCLK
Port A pin 1: clear DAC pin
From the API shown in the link bellow,I have only _USART_ROUTE_LOCATION_LOC0 .
How do i Put set my actual locations Using the API of SPIDRV?
Thanks.
**broken link removed**
When i define USART in SPI mode i need to define the pins and ports as follwoing:
Port A pin 2: chip select sync_not (active low)
Port E pin 10: MOSI (SDIN)
Port E pin 11: MISO (serial interface digital out)
Port E pin 12: SCLK
Port A pin 1: clear DAC pin
From the API shown in the link bellow,I have only _USART_ROUTE_LOCATION_LOC0 .
How do i Put set my actual locations Using the API of SPIDRV?
Thanks.
**broken link removed**