wonghonyin
Newbie level 1
Hi,
I am new into the SPI testing and trying to verify the SPI interface is working.
The board I am using is TI L138 and it has only one SPI interface.
Is it possible to directly connect the MISO with the MOSI pins to perform a loop back test? So far, it's not working. Anything else I should do to get this working?
I have verified using scope that there is output at MOSI.
thanks
Francis
I am new into the SPI testing and trying to verify the SPI interface is working.
The board I am using is TI L138 and it has only one SPI interface.
Is it possible to directly connect the MISO with the MOSI pins to perform a loop back test? So far, it's not working. Anything else I should do to get this working?
I have verified using scope that there is output at MOSI.
thanks
Francis