Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am going to use the speed controller (in attached image) for my 8-9 A 12V radiator motor. Is it better choice, if not, then which one would be better? Will it also cause to take less Amp from battery?
The 7555 has very low output current. The 2.2k output resistor can drive an N-channel Mosfet that can apply PWM speed control to the high current motor. PWM is an efficient way (very little current is wasted) to control the speed of a DC motor.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
