Hi jiripolivka,
Thanks for the support.
Actually I have read the Agilent Specification but I didn't find about how DC voltage can bear the instrument.
My thesis project is very simple, I have two Power Line Modem Developer's Kit (TMDSPLCKIT-V3) where one send a packet (TX) and the other modem receive this packet (RX) and then simply it generates a PWM signal on site, nothing else.
Everything works but my next step is to "sense" the channel (between TX and RX) in terms of noise/interferences.
In that way I will send the packet from the TX in the range of frequency with lower noise/interferences.
My question is: How can I perform a DC channel sensing?
Thanks for the support,
Best,
Andrea