Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

source pull in ADS need help

Status
Not open for further replies.

TerryADS

Full Member level 2
Joined
Oct 31, 2008
Messages
133
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Location
USA
Activity points
2,066
Hi friends,
Always we need do load pull simulation firstly and get the optimum load,and secondly run source pull simulation.My question,how to set Load impedance when i do source pull simulation?I need set it optimum load or other (considering Harmonic pull)?
Thanks,
 

TerryADS said:
Hi friends,
Always we need do load pull simulation firstly and get the optimum load,and secondly run source pull simulation.My question,how to set Load impedance when i do source pull simulation?I need set it optimum load or other (considering Harmonic pull)?
Thanks,

Of course use the 'optimum' Load,
maybe after your source pull, you should do load pull again, and them source pull again and again

iteration may be necessary...
 

    TerryADS

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top