Zorah_Ahmad
Newbie level 6
I'm new to Solidworks and I am attempting to carry out a design study. I carried out a static analysis as shown in figure q
As you can see the max deflection is 3.752 um whereas the min deflection is -1.054 e-7 m. I wanted to optimize certain dimensions such that the displacement of 3.752 um is further maximized. I attempted to do so according to the guidelines provided online but for some reason, the optimization process attempts to maximize the -1.054 e-7 m deflection instead of the 3.752 um deflection as shown in figure 2
What should I do to rectify this?
As you can see the max deflection is 3.752 um whereas the min deflection is -1.054 e-7 m. I wanted to optimize certain dimensions such that the displacement of 3.752 um is further maximized. I attempted to do so according to the guidelines provided online but for some reason, the optimization process attempts to maximize the -1.054 e-7 m deflection instead of the 3.752 um deflection as shown in figure 2
What should I do to rectify this?
