Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

solid state flash drive interfacing with microcontroller

Status
Not open for further replies.
N

NOORPURI

Junior Member level 3
Joined
Jun 29, 2006
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,549
I am trying to interface At89C52 with Simpletech Solid-state IDE flash disk with combination of 16-line data bus , 2-line chip select, 3-line address , RD & WR signals.

I have followed ata/atapi spec and many other design and sample codes . but when i captured the signal by connecting Flash disk with singal board computer then i found there is some difference in steps.

If any one did this task please help me.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top