Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Soldering tips for this circuit on veroboard to reduce EMI

Status
Not open for further replies.
Z

zenniz

Junior Member level 3
Junior Member level 3
Joined
Mar 25, 2013
Messages
29
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Singapore
Activity points
1,497
I'm building a switching regulator on a Veroboard. I need it to be as compact as possible and at the same time low EMI noise.
Any tips on the placement of those component on a Veroboard?

Output is 5V 1A.
The TL2575 switching regulator is a 5 pin TO-220 packaging with a 20x10x20mm heatsink.

12345.png
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top