Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The solder mask is a layer where it is expected to leave the copper exposed which is then tinned. The rest area will be covered by the solder mask. The pads where the solder mask should'nt be applied needs to be alligned first so as not to mask the soldering areas of the PCB. This proceidure is usually called the solder mask alignment.
Cheers
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
