hi......im using AT89S8252 micro controller ic for my project ............i need to burn d program into this ic........BUT in order to do dat i need to first convert the file into binary or hex file(is there any software available to do so)................CAN ANYONE TELL me how to do tht??????????
Hi!
Keil software works both with assembly(.asm) files and C files(.c).It automatically generates the "hex" file which can be directly programmed in the
controller using any programmer.
Visit this site and you will get at lot of help for 8051. www.kmitl.ac.th/~kswichit/shiao/prog.htm
Regards.
Hi,
Any 8052 based ASM or C will do. C is already mentioned, visit Atmel site, it used to provide free ASMs.You can also check at site 8052.com.
Regards, Laktronics
Hi!
ISP means In System Programming. With ISP you don't have to pull out the chip from your application circuit for programming. ISP is serial communication based and uses very few connections as compared to the old parallel programming method which used a lot of connections to the microcontroller being programmed.
I have attached the software and hardware schematic for Atmel ISP.
Regards.