Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Snubber circuit design for BTA41 600BT Triac

Status
Not open for further replies.

Mrunal Ahirrao

Full Member level 2
Joined
Nov 26, 2012
Messages
133
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Location
India
Activity points
2,213
Hi all,
I want to control AC water pump which may be having max current=10A using BTA41600B Triac. And I quiet new to designing snubber circuit for such high load. And I am not getting the values for R and C and I read in application note that "R" should be a snubber resistor. What is snubber resistor? is it the High wattage resistor? Any help would be appreciated.
 

Assume single phase motor. Use high rating relay having current capacity 20A or 10A for inductive load which is easy.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top