Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Snubber Circuit Calculation for Triac based AC motor Control

Status
Not open for further replies.
H

htekin42

Member level 2
Joined
Dec 10, 2012
Messages
45
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,699
Dear All,

I am designing a circuit to control AC motor direction. I am using BTA16-800CW and I am using MOC3041 triac driver to drive it with microcontroller. I am using P275L40B MOV to protect triac but I am confused about snubber circuit. How can I determine the values of R and C values? Could you please explain the calculation of them?

Motor characteristics; 1/4HP 0.18kW 1,6A 220V 50Hz Run capacitor type AC induction Motor.

Circuit schematic is added
circuit.jpg

Thanks for helps
Best Regards.
 

Use the attached files, there are a lot of information and calculations
 

Attachments

  • RC SNUBBER NETWORK.pdf
    454 KB · Views: 397
  • CONTROL BY A TRIAC FOR AN INDUCTIVE LOAD.pdf
    92 KB · Views: 386
  • Driving Triacs with Phototriacs.pdf
    56.6 KB · Views: 376
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top