Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SNR @ input of A/D converter [hlp]

Status
Not open for further replies.
N

No one

Full Member level 5
Joined
May 11, 2005
Messages
287
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,298
Activity points
3,425
Hello Everyone;
How can I calculate the required Signal-to-Noise ratio at the input of an A/D converter?
 

Hi
I can give some ideas about how to caculate needed SNR at the input to the ADC. Obviously this is heavily dependent on ADC dynamic range, SFDR, sampling rate and more ....

I think that the best solution is to study a complete datasheet of an ADC. Maxim-ic.com is a very great source. Also texas instruments provides valuable info.
 

    N

    No one

    Points: 2
    Helpful Answer Positive Rating
Hi

Are you going to calculate required SNR at the input of ADC to account for Quantization noise?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top