Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

smc91c111 ethernet linux driver problem

Status
Not open for further replies.
S

shastri.vs

Member level 2
Joined
Dec 16, 2008
Messages
45
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,600
hi,
I am writing ethernet driver for smc91c111 lan controller for Gumstix board with PXA270 processor.
Problem is I am not able configure any of the registers. From linux I am writing value but when I readback I am getting only FFFF.
The GPIO pin of pxa is acting as Chip select for lan controller.

I am newbee in this please help.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top