Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

slant polarization for horn antenna

Status
Not open for further replies.

aghil139

Newbie level 5
Newbie level 5
Joined
Jul 26, 2013
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
47
hi.
im working on a linear horn array with slant polarization, from 6-18GHz .
could any body help me in a proper horn element with slant polarization.
or a technique to rotate 45 degree the polarization.
thanks.
 

Try a quarter-wave plate inserted in the feed waveguide diagonal. Use a thin Teflon plate or a similar dielectric.
I doubt it could work over the extremely wide bandwidth, though. Why you simply do not tilt the horns by 45 degrees?
 

hi.
i think using a wave plate leads to more power loss.
and i want to use it in linear array. tilting the horns make mutual coupling and isolation become difficult.
could i design a dual polarized horn and use it for slant polarization?
 

I tried quarter-wave plate and saw no loss. BY tilting the horns you can get the goal but you must test the full radiation pattern to check coupling.
Using dual-polarized horns is possible but again you must know the full radiation pattern (not only E and H) to check coupling.
Dual-polarized horn needs to control amplitude and phase to specify the tilt, and all affects the radiation pattern.

I would prefer to experiment, take two horns and see what happens and what works best.
 

i think using wave plate restricts the bandwidth. designing such wave plates is difficult.
could u help me in design a broad band quarter wave plate? like an HFSS file or a text?
thanks
 

i think using wave plate restricts the bandwidth. designing such wave plates is difficult.
could u help me in design a broad band quarter wave plate? like an HFSS file or a text?
thanks

Sorry, I cannot. I prefer experiments. Your wideband case is quite challenging I think.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top