Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

simulation warning message in ADS! PLS HELP!

Status
Not open for further replies.

modelstudent

Newbie level 6
Joined
Aug 12, 2010
Messages
14
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,370
I am designing a multi band antenna and i use ADS to simulate it, i have some warning message when it simulating the S-parameters:
inaccuate (high frequency ) calibration;
electrically large via using lumped model;
higher order modes at the ports;
grouped strip-slot ports;
mesh density is too coarse;



can anyone tell me why did this happen??
thanks!!!
 

hieuphong

Newbie level 6
Joined
Nov 5, 2010
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
coltech_VNU_VietNam
Activity points
1,330
i think you need calibration again... Maybe you have to calibrate and increase distance frequency
 

modelstudent

Newbie level 6
Joined
Aug 12, 2010
Messages
14
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,370
i am using a partial ground plane for my antenna ( using layer cond2)
should i place a port on layer cond2 to ground it?
or only one port on layer cond for input is enough?
 

farhill

Newbie level 5
Joined
May 25, 2009
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,330
I met the same warning. Can someone offer more explanations on how to handle this?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top