Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

simulation of tapered coupler

Status
Not open for further replies.

sm_ali_sadreghaeni

Newbie level 5
Newbie level 5
Joined
Jan 3, 2010
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,341
Hi
I design an broadband taper coupler and have a dxf file.
I want to import DXF file in momentum environment of ADS.
but it display only boundary of conduct part of coupler.
What is solution to import coupler to ADS completely ?
 

Hi
I design an broadband taper coupler and have a dxf file.
I want to import DXF file in momentum environment of ADS.
but it display only boundary of conduct part of coupler.
What is solution to import coupler to ADS completely ?

You should try Microwave Office. It allows direct import of DXF for EM simulation and is much easier to use than ADS.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top