Simulation and Analysis Environment

[barbs2021]

Hello everyone,

I am using Synopsys Custom Designer Tool. I have done "SAE"(Simulation and Analysis Environment) for my circuit already. Now, my problem is that how can I determine the results (parameters) e.g., power dissipation etc.?

Attached below is a snapshot of my simulation(transient analysis) for a comparator circuit.

 

[martinnl]

I am not familiar with Synopsys SAE but it all depends on the parameters you need. For power consumption you can save the current into your DUT, run a transient, average the current, and calculate the power from the current and the supply voltage.

Also your testbench seems to have some issues. Is it your intention to have such a low INP? It barely reaches the same voltage as INN. Also the input frequency is very high compared to the clock frequency.