Sherihan
Newbie level 1
Hello everyone,
i want to simulate a rectifier efficiency in ADS for different loads without taking the mismatch losses in consideration, so am i doing it right? (My simulation setup is attached here)
if i'm doing it right, why by changing the source impedance the values of max efficiency changes (as shown in the attached figures) although i'm not taking the mismatch losses in consideration?!
i want to simulate a rectifier efficiency in ADS for different loads without taking the mismatch losses in consideration, so am i doing it right? (My simulation setup is attached here)
if i'm doing it right, why by changing the source impedance the values of max efficiency changes (as shown in the attached figures) although i'm not taking the mismatch losses in consideration?!