Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[General] SIM928 using a single UART

Status
Not open for further replies.
W

watteljacques

Newbie level 1
Joined
Jul 22, 2013
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
7
Hi,

I'm building an expansion board for a Raspberry PI using the SIM928. Is it possible to use the SIM928 using a single UART to access the GSM/GPRS as well as GPS? I know it is possible with its predecessor the SIM908.

Thanks
 

I think the 928 has a superset of then AT commands from the sim908, and thus, it has the AT commands to read the NMEA packets by a single serial interface...

but please check that some commands are different and probably you can't make a direct change of a SIM908 with a SIM928. (I remember checking the commands for gps warm/cold reset and they were different on those modules)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top