Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

sim300c echoing at commands

Status
Not open for further replies.

bilgekaan

Full Member level 2
Joined
Nov 18, 2004
Messages
125
Helped
15
Reputation
30
Reaction score
1
Trophy points
1,298
Location
Turkiye
Activity points
1,300
Hello,
I have sim300dz module on sim300c eVB 2.01 board. When I poer up board, I receive call ready message.İf I try to send At commands , board is just echoing At command I sent .
Not responding my commands. I Am usşng only RX and TX signals.Not using control signals( RTS ,DTe ,,etc) . What I undersatnd from blink led is my module is found the gsm network.
I am waiting for your suggestion.
Regards
Bilge
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top