Should I use Cgd or Cdg

Status
Not open for further replies.
W

wangkes

Newbie level 3
Joined
Jun 18, 2011
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,306
Cgd and Cdg is different in spice for mos device.

Should I use Cgd or Cdg such as in calculating miller cap in a CS stage?

And which does spice use with these cap ( Cgs, Csg ....), or it will not use these cap in calcutating some results, just do some iteration ?

Thanks!
 

The following paper is a good ref. for you:
A One-Step Input Matching Method for Cascode CMOS Low-Noise Amplifiers
**broken link removed**
 

According to HSpice manual CGD equals (-) derivative of gate charge to drain voltage, and CDG equals (-) derivative of drain charge to gate voltage, and are called Miller feedback and feedthrough.
Therefore when your see through the gate you must use CGD, CGS, and CGB. (the parameters cgs, cgd you give using .OP are the same CGD, and CGS)
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…